Ideal Product Categories

About Us

cable, vdsl, patch

 

Hyperline- Ideal Industries Cutters - Coax/Twisted Pair Cutters - Twisted Pair Cutters - Coax Cutters - Fiber Cutters Fiber Optic Test Equipment- Ideal Industries


American Tech Supply is now an authorized Hyperline distributor

From copper to fiber, the Hyperline system of products includes everything you need for installation, termination, testing and troubleshooting. And our level of technical expertise, training and customer support ensures that your total cost of ownership is kept to a minimum.

Soundproofing

Important information:
The most important parameters for Hyperline flooring systems are described in the overview below.

Rated degree of longitudinal sound reduction as per DIN 52 210 RL,w,P?and Dn,f,w,P?acc. to ISO 140-12
The measurement is taken horizontally with a high-performance soundinsulating partition wall placed on the system floor. This determines an index figure for the floor, which can be used to calculate the sound insulation index from room to room, incorporating the other flanks and the partitioning wall in the building. Higher figures are better as they indicate a higher insulating value.


Sound insulation index Rw,P?as per DIN 52 210 and ISO 140-3
The measurement is taken vertically, i.e. from one story of the building to another, with a standardized structural ceiling. This allows different systems to be compared. A conversion has to be performed to allow for the structural conditions if the actual structural ceiling differs in its structure. Higher figures are better (due to the higher insulating value).


Rated footfall sound level Ln,w,P?as per DIN 52 210 and Ln,f,w,P?acc. to ISO 140-12
The measurement is taken vertically, i.e. from one story of the building to another, with a standardized structural ceiling. This allows different systems to be compared. A conversion has to be performed to allow for the structural conditions if the actual structural ceiling differs in its structure. Higher figures are better (due to the higher insulating value).


Degree of improvement in footfall sound ? Lw,P?as per DIN 52 210 and ISO 140-8
The measurement is taken vertically, i.e. from one story of the building to another, with a standardized structural ceiling. This allows different systems to be compared. However, a conversion has to be performed to allow for the structural conditions in this case, too, if the actual structural ceiling differs in its structure. Higher figures are better (due to the greater degree of improvement).
The floor covering is not relevant to airborne sound reduction for the hollow floor. The results for footfall sound reduction depend on the degree to which the floor covering provides an improvement. Ventilation openings, which might lower the degree of soundproofing, have not been taken into account.
To calculate values for a building, the corrective degrees should be allowed for acc. to VDI 3762. Combinations of access floors and hollow floors should be assessed in each individual case. The corrective degrees should be determined by the planner.

?


 

 

 

Call (866) 342-3721 Or Click On The Chat Button At The Top Of The Page To Talk To One Of Our Representatives

 

 

 

 

 

 

 

BIF-Bend Insensitive Fiber