MRV Products
The Fiber Driver? T1 Fiber Multiplexer from MRV
Communications transmits four T1 data channels across a fiber optic trunk in a
Point-to-Point (PtP) configuration. Each line interface consists of a B8ZS, or
AMI encoder/decoder as applicable, and a receiver with equalizer for reliable
data and clock recovery. The device also includes a crystal-less jitter
attenuator which, depending on system requirements, can be set in the transmit
(TX) or receive (RX) path. Line distances from 0 to 100 m are supported. Line
protection is designed to meet Telecordia GR-1089.
The fiber trunk can be
either Singlemode or Multimode, dual or single fiber, using LC, SC, or DSC
connectors. The T1 Fiber Mux can also be configured with the Multimode Extender
(MMX) transceiver. With MMX technology, available exclusively from MRV
Communications in the Fiber Driver product line, a link of up to 6 km can be
achieved over a Multimode fiber trunk.
The T1 Fiber Mux offers extensive
management functions. Diagnostic LED indicators ease installation and
troubleshooting. When paired with the Fiber Driver Network Management Module
(EM316NM), system activities such as loss of signal, transmit and receive signal
detection, system temperature, power supply status, and more can be monitored
remotely via SNMP using MegaVision Web, MRV Communications own Network
Management System (NMS), or any other standard NMS. On-card jumpers allow for
manual configuration of local and remote loopback, jitter attenuation, and other
settings. |
 |
MRV
|
