Raisecom- RC702-GESTM4- Gigabit Ethernet over SDH STM 4- Ethernet over SDH- Ethernet over Fiber- Ethernet over PDH- Ethernet over SDH- Ethernet over Copper

Ethernet over SDH

Ethernet over SDH network termination equipment provides simple and cost-effective solution for bridging Fast and Gigabit Ethernet traffic over STM-1 or STM-4 circuits. They are widely used for backhauling mobile base stations and IP DSLAMs, providing from N*2Mbps to wire-speed Ethernet connections.

RC702-GESTM4

Gigabit Ethernet over SDH STM-4

Connects Gigabit Ethernet over STM-4 circuits
Aggregate 8 Fast Ethernet over two STM-4 circuits
Modular design of Gigabit Ethernet interface for flexible networking
Optional Gigabit Ethernet extension card for cost-effective Gigabit Ethernet over STM-4 application
Optional Gigabit Ethernet extension card for enhanced Gigabit Ethernet over STM-4 transmission with SLA
Optional Gigabit Ethernet extension card for aggregating 8 Fast Ethernet over two STM-4 circuits
Supports VC12/VC3/VC4 mapping
Supports VC12/VC3 VCAT (ITU G.7043) and LCAS (ITU G.7042)
Supports standard encapsulation with GFP (ITU G.8040) and LAPS (ITU X.86)
VLAN tagging, stacking and switching
Rate limiting on Gigabit Ethernet port in both ingress and egress direction
QoS based on COS, DSCP and IP precedence
End-to-end performance test and near-end/far-end fault alarms
Redundant hot-swappable power supply
Remote management using the network port or out-of-band Ethernet port

e, vdsl, patch

Ethernet over SDH

RC702-GESTM4