MRV Products
The Fiber DriverT E1 Fiber Multiplexer from MRV
Communications transmits four E1 data channels across a fiber optic trunk in a
Point-to-Point (PtP) configuration. Each line interface consists of a HDB3
encoder/decoder, and a receiver with equalizer for reliable data and clock
recovery. The device also includes a crystal-less jitter attenuator which,
depending on system requirements, can be set in the transmit (TX) or receive
(RX) path. Line distances from 0 to 100m are supported. Line protection is
designed to meet Telecordia GR-1089 standards. The Fiber Driver E1 Fiber Mux is
G.703 interface and G.704 framing compliant.
The fiber trunk can be
either Singlemode or Multimode, dual or single fiber, using LC, SC, or DSC
connectors. The E1 Fiber Mux can also be configured with the Multimode Extender
(MMX) transceiver. With MMX technology - available exclusively from MRV
Communications in the Fiber Driver product line - a link of up to 6 km can be
achieved over a Multimode fiber trunk.
The E1 Fiber Mux offers extensive
management functions. Diagnostic LED indicators ease installation and
troubleshooting. When paired with the Fiber Driver Network Management Module
(EM316NM), system activities such as loss of signal, transmit and receive signal
detection, system temperature, power supply status, and more can be monitored
remotely via SNMP using MegaVision Web, MRV Communications own Network
Management System (NMS), or any other standard NMS. On-card jumpers allow for
manual configuration of local and remote loopback, jitter attenuation, and other
settings. |
|
MRV Products
By Category
Out-of-Band Console & Power Management
Pluggables
Wave Division Multiplexing
By Product Line
OptiSwitch
TereScope
|